Alumilite Water Clear produces a high impact rigid clear casting that is commonly used for lenses, encapsulations, and water reproductions. Vacuum or pressure is recommended to achieve 100% bubble free castings.
The Water Clear has a new 15 minute open time and a 2-3 hour demold time.
Alumilite Water Clear must be mixed 1:1 by weight. Off ratio mixing may produce hazy or frosted parts.
Recommended for industrial use only.
|Products||Alumilite Water Clear|
|Mix Ratio||1:1 by WEIGHT|
|Pot Life||15 minutes|
|Demold Time (100 gr. Mass)||2 -3 hours|
|Mixed Viscosity (cps.)||400|
|Shore Hardness (ASTM D-2240)||72D|
|Tensile Strength (ASTM D-638) (psi)||3,120|
|Temperature Resistance||140 F|
Mold Preparation : Warm mold to 125 – 150ºF before pouring. (Highly recommended for parts less than 1/4″)
Mix Instructions : Measure equal parts by weight of side “A” and “B”, mix thoroughly, and pour. Work time is 7 minutes with a demold time of 45 – 90 minutes depending on temperature, mass and thickness of piece.
NOTE : Vacuum degassing resin can significantly reduce air bubbles in castings. Mixed Alumilite Water Clear degas much more quickly if the A & B are degassed separately prior to mixing together. For best results, pressure casting is recommended to produce bubble-free castings.
- Wear appropriate protective gloves and protective spectacles.
- Wash hand well after handling.
- Avoid discharge into the environment.
Please watch the video above for a quick demo.
For more tutorials, visit Alumilite Mold Making and Casting Tutorial
For complete instructions visit www.alumilite.com
Made in USA.
Prior to use, read all Technical Data Sheets/Instructions and Safety Data Sheets.
Please send us an e-mail at firstname.lastname@example.org to check on the stock availability.
More craft materials available online and at our craft shop at Craftiviti Sdn. Bhd. (Petaling Jaya, Malaysia)